knife out of position on swf embroidery machine

This brings us up to stitch 1957 of 4807 as displayed on the Stitch Info screen.

To get close to our goal press the START button nine times.

100 stitch' which is fine for this example.

In this example, our goal is to get to 1968 so we need to change the increments we increase by to 100.

Watch the Stitch Info screen for details.

If during the course of pressing START to progress through the design you happened to go beyond to number of stitches you intended, press the STOP button to reverse the same amount of stitches.Since earlier in this exercise we established being at stitch 57 this step took us to stitch 1057. Press the DOWN button, which will take the cursor to '2.1000 stitch'.For this example lets pretend we have a 4807-stitch design and we need to get to stitch number 1968.Turn all of the heads on the machine back on by pressing the Head On/Off Switch.For this example that took me to stitch 57.

Hesitate for approximately eight seconds then press the STOP button.Turn all of the heads on the machine off by pressing the Head On/Off Switch on the Thread Tension Unit.If you have sewn at least one stitch go to # 8, if not go to #4.You must have at least one stitch sewn in the design for the float command to work.How do I DELETE A DESIGN from the machine?.Press the DOWN ARROW button (F2) to access the Y SATIN command (#6).Press the DOWN ARROW button (F2) to access the X SATIN command (#5).The machine will display Y SATIN: 0 These numbers represent the degree to which all satin columns within the design will be increased vertically.Press the DOWN button to access the Y SATIN command (#7).The machine will display X SATIN: 0 These numbers represent the degree to which all satin columns within the design will be increased horizontally.Press the DOWN button to access the X SATIN command (#6).

Knife out of position on swf embroidery machine